Rental GAC Equipment Provides Municipal Water Systems With Quick, Feasible Option for Addressing Problems

Sussex County, Del., upgraded its equipment and purchased two TIGG CANSORB CP-8000 vessels with the combined ability to purify 1,440,000 gallons of drinking water per day.

By Tom Bourke

     Municipal drinking water providers looking to quickly come into regulatory compliance or to solve other potable water problems where activated carbon adsorption vessels are the answer sometimes turn to rental equipment as a quick remedy. As the efficiency and cost factors are evaluated over time, the rented vessels can be purchased or upgraded as a permanent drinking water purification solution.
     When Sussex County, Del. saw a steady increase in tetrachloroethylene (PCE) levels in potable water at its Industrial Airpark Well #2, engineering consultants began evaluating three different methods of treatment. These possible treatment technologies included ion exchange, which was found to be ineffective in removing PCE; air stripping, which required additional pumping; and activated carbon, which was determined to be the most effective and economical solution.
     "The Delaware Division of Public Health did a random test at the Sussex County Industrial Airpark system and discovered relatively high concentrations of PCE," said Heather Sheridan, Sussex County director of environmental services. "Though the concentration was below the state's maximum contaminant level, we wanted to take a proactive approach. On the advice of our consultants we moved quickly to install GAC water treatment equipment."
     The Industrial Airpark system serves 27 industries and approximately 900 people on 600 acres of developed land at the Sussex County Airport. Overall, the county operates two potable water systems and four wastewater treatment facilities serving a total of 64,775 equivalent dwelling units.
     The county's Department of Environmental Services, which runs and maintains the two systems, deemed the PCE concentration level an emergency and decided that renting a GAC adsorption system was the fastest way to address the issue.
     The nature of the problem required an immediate response and meant the normal bidding process was put on hold until a temporary system was installed. The Sussex County Engineering Department rented and installed two CANSORB CP-3,000 activated carbon adsorption vessels. Each of the GAC units handle a maximum flow rate of 235 gpm, have a maximum pressure of 75 psi and have a standard media fill of 3,000 lbs of activated carbon.
     "The filter units were delivered in a matter of days," said Julie Cooper, a Sussex County project engineer. "The county staff provided the materials and labor for installation and piping."
     According to Cooper, before the Industrial Airpark Well #2 was put online with the two rented vessels running in parallel, sampling was done before and after the filtration vessels. Once the filtration units were installed, testing revealed the contaminant influent level was 4.5 micrograms per liter and after treatment the effluent level was less than 0 micrograms per liter.
     "Activated carbon is a good adsorption media for a multitude of organic compounds and PCE is one of them," said Anthony Mazzoni, TIGG Corporation vice president. "It's a textbook application. PCE is strongly adsorbed by activated carbon, even at low concentrations."
     TIGG designed, manufactured and delivered the rental GAC units and once they were operational the company's technical experts worked with Sussex County's staff to create a permanent filtration solution. Due to county requirements, the project for permanent potable water filtration units was put out to bid.
     When looking to purchase new GAC units, Sussex County decided to upgrade from the 3,000 pound carbon bed in the rental units and go with two adsorbers with a maximum flow rate of 500 gpm, 125 psi, and a 10,000 activated carbon bed. This upgrade allowed the system to operate at higher flow rates and the larger carbon bed increased the amount of time in between spent carbon change outs.
     "The TIGG model was used as a basis for specification, though Sussex County specifications allowed for an approved equivalent," Cooper said. "However, the units submitted by the successful bidder on the permanent installation project were TIGG vessels.
     Sussex County acquired two CANSORB CP-8,000 units. The piping and valving was designed so that the two vessels would run in lead-lag configuration. Once the lead vessel's medium is spent, the system can be valved to run only through the lag vessel. When the carbon in the isolated vessel is replaced, the system is then set to lead-lag again, with the replenished vessel becoming the lag vessel. Thus, the two vessels are replenished with new carbon alternately and the system is never off line.
     These two units are capable of purifying a combined 1,440,000 gallons of water a day. They are constructed of carbon steel and are lined on the inside with an NSF-approved high solids epoxy for potable service to help prevent corrosion.
     The CANSORB-P line is specifically engineered to promote the even distribution of water as it travels downward through the carbon bed. The area where the carbon actively adsorbs contaminants from the influent water is the mass transfer zone. As the carbon becomes spent the mass transfer zone moves down the bed. The flow rate and contaminant concentration levels are factors in determining how quickly the carbon reaches capacity.
     Once the mass transfer zone progresses to the end of the bed, the effluent concentration increases to a level which is unacceptable for continued operation. This concentration is called the breakthrough point. At this point, the carbon bed is usually exchanged.
     The goal of a well-designed adsorption vessel is to evenly distribute the water in the unit in order for the mass transfer zone to move evenly through the depth of the carbon bed.
     While Sussex County rented its GAC equipment to get out in front of a potential PCE problem, the San Antonio Water System (SAWS) rented activated carbon adsorption systems to proactively remove TOC and TTHMs from Canyon Lake, a Central Texas potable surface water supply. SAWS wanted to reduce the potential for formation of disinfection byproducts (DBP) in its distribution system, and ensure compliance with EPA Stage 2 DBP regulations.
     Disinfection byproducts occur when disinfectants such as chlorine react with naturally-occurring organic compounds in water. The disinfection agents are added to source water to control pathogenic microbes. However, they react with organic matter in the source water to form potentially harmful substances.
     The type of DBP can vary depending on the disinfection agent used, the concentration of organic matter, the pH levels of the water and even the temperatures when the process occurs. Other factors can contribute to the DBP levels as the water travels through pipe networks toward the taps of consumers.
     If consumed regularly over a long period of time the accumulation of DPB in the human body may lead to certain health risks. Some studies have shown high doses of DBP may have a carcinogenic effect as well causing reproductive issues.
     "The EPA promulgated a series of rules in the late 1990s and mid 2000s to limit the formation of DBPs while optimizing the control of pathogens. If EPA promulgates something, the states have to follow suit," said Lisa Kasianowitz, Pennsylvania Department of Environmental Protection media spokeswoman.
     "Compliance monitoring is phased in for larger systems to smaller systems. Some water systems began compliance monitoring under the Stage 2 DBPR in April 2012. Others must comply by October 2013 or October 2014. They've known well enough in advance so water systems have had time to prepare for the compliance monitoring."

Employees of the San Antonio Water System assemble one of three rental skid system units August 14. The combined systems are capable of purifying more than 5 million gallons of drinking water per day.

    SAWS rented three activated carbon dual-vessel skid systems that went online in San Antonio, August 14. The combined systems are capable of purifying more than 5 million gallons of water a day. The units can run either in series or parallel. Each system holds 40,000 lbs of granular activated carbon and purifies water at 1,500 gpm.
     The dual-vessel systems are comprised of two CP20K-10 granular activated carbon adsorption vessels connected with a 12-valve pipe rack. In order to meet their flow rate requirements, the SAWS system is operated in parallel.
     "Granulated Activated Carbon might be an appropriate treatment technique for DBP removal but it is not the only option," Kasianowitz said. "In Pennsylvania, any installation of GAC equipment will require a consultation and permit application through the appropriate Department of Environmental Protection regional office. States that have primary enforcement authority for the federal regulations must promulgate regulations at least as stringent as the federal standards; however, some states may choose to implement regulations that are more stringent than federal regulations."
     TIGG won the competitively bid contract to rent the units to the San Antonio Water System on July 3. The agreement could be worth up to $2.5 million and includes spent carbon exchange and disposal services
     "Although we've been manufacturing the dual-vessel CP 20K-10 system for years, this is the first time we've supplied a client with the complete system on a skid," Mazzoni said. "We specifically engineered each skid to ship on a single flatbed truck. Plus, the skids simplify the setup process and help reduce labor costs."
     The deadline for some water providers serving less than 10,000 people to come into compliance with the EPA's Stage 2 DBP Regulations occurs in 2013, with possible extensions granted. However, with limited money available and regulations looming renting GAC equipment can be a way to meet the regulatory deadlines. This factor, along with reduced up front capital costs and quick response times to emergency situations makes rental GAC adsorption equipment a viable option for many municipal water providers.

For more information on TIGG's Municipal Applications such as drinking water purification equipment, hydropneumatic surge tanks, multi-media filters and activated carbon media call 800-925-0011 or contact us.

TIGG Receives Women's Business Enterprise National Council Certification

TIGG Receives Women's Business Enterprise National Council Certification
Company’s woman-owned status helps clients meet diversity goals

Georgiana Riley joined TIGG as Director of Sales in 1993. In 1996, she became President of TIGG. In 1999, she purchased the company from the founder’s family and since then has concentrated on improving every department.

OAKDALE, Pa., March 18 ― TIGG Corporation, a manufacturer of steel tanks and pressure vessels that are primarily used as activated carbon adsorption and filtration units for environmental remediation, industrial emission control and other water and air purification applications recently received national certification from the Woman’s Business Enterprise National Council (WBENC).
            Many corporations as well as federal, state and local governments strive to include woman-owned businesses on their list of preferred vendors. By obtaining its WBENC certificate, TIGG is easily identified as a woman-owned company.
            “More and more of our customers have made a commitment to diversity in their supply chain,’ said TIGG Owner Georgiana Riley, who purchased the company in 1999. “We are pleased to receive the WBENC certification because it allows us to better serve clients who place a priority on inclusiveness.”
            Prior to owning the company, Riley worked in several areas of the activated carbon industry including chemistry, sales, marketing and management. In addition to being the president/owner of TIGG, she is on the board of directors of Catalyst Connection, the board of Adagio Health and is the chairperson of her local sewage authority.
            In order to achieve its WBENC status, TIGG underwent a rigorous certification process that included a review of the company’s corporate by laws, financial and tax information, articles of incorporation and an on-site inspection. The certification is already paying off—in 2012, the WBENC certification helped TIGG meet the diversity requirements of one of the company's largest clients.
            TIGG is also certified as a woman-owned business with the Port Authority of New York and New Jersey and the California Public Utilities Commission. With a state-of-the-art manufacturing facility, a team of highly skilled workers, an experienced engineering department and more than 35 years in business, not only is TIGG a certified woman-owned business, it is also an innovative industry leader.


Download A PDF | Woman-Owned Business Capabilities Brochure
View TIGG's WBENC Certificate
Visit TIGG's CERTIFICATIONS page for more information on the company's woman owned business status.

TIGG Names Doug Murray New Plant Manager

Murray Brings Manufacturing Experience to Heber Springs, Ark. Facility

Taking over leadership of TIGG’s Heber Springs, Ark. production facility February 11, Doug Murray brings years of manufacturing experience to the company. With a bachelor’s in science from Missouri State University, he has been exposed to many business aspects including accounting, human resources economics and operations management.

HEBER SPRINGS, Ark., March 27 ― TIGG Corporation announced the February 11 hiring of Doug Murray as the company’s Heber Springs, Ark. manufacturing facility plant manager. In his new position, Murray will direct all plant activities including production, warehousing and distribution while managing costs and implementing worker safety programs.
            “Several qualified candidates applied for the position and it was tough narrowing it down to just one,” said TIGG President Georgiana Riley. “However, we’re confident we made the right choice and that hiring Doug will help TIGG continue to produce quality equipment for its customers.”
            Previously, Murray oversaw 63 workers on four production lines while employed as the supervisor of manufacturing at a carbide forming and shaping facility. He sees both similarities and differences between his old and new positions.
            “The biggest thing we made at my old job was the size of a coffee cup. Now, I’m making equipment that takes a semi-trailer to deliver,” Murray said. “But, just like before, my job is focused on satisfying customer needs in a manufacturing environment.”
            TIGG employees will see changes moving forward at the plant that will come in short bursts. Murray said his main approach would be to utilize basic lean principals, which include streamlining the manufacturing processes, enhancing the management of employee hours and ensuring required materials are ready at each stage of the process.
            “At TIGG, we’re geared up to expand and hope to increase our 21-person Heber Springs workforce if sales growth continues,” Murray said. “I also hope TIGG can become more involved in the community and local functions.
           TIGG has more than 35 years of experience designing and building steel tanks and pressure vessels that are primarily used for air and water purification. The company has 155,000 square feet of fabrication and warehouse space in Heber Springs and a headquarters facility in Oakdale, Pa.

For more information visit www.TIGG.com